Taurus FWD V6-3.5L (2008)
3. Remove the outboard safety belt anchor bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
4. Remove the upper and lower C-pillar trim panels.
5. Remove the bolt and the outboard safety belt retractor.
-
To install, tighten to 40 Nm (30 lb-ft).
6. NOTE:
-
Make sure the safety belt webbing is not twisted prior to installation.
-
During installation the web loop position of the safety belt anchor must face outboard of the vehicle.
To install, reverse the removal procedure.
7. Check the active restraint system for correct operation.
