Taurus FWD V6-3.5L (2008)
8. After separating the lower arm ball joint from the wheel knuckle, immediately install the special tool over the ball stud before releasing the lower
arm and knuckle into the rest position.
^
Leave the special tool in place during service, only remove prior to reassembly.
9. CAUTION: Do not allow the halfshaft to move outboard. Overextension of the tripod constant velocity (CV) joint may result in
separation of internal parts, causing failure of the halfshaft.
Using the special tool, press the halfshaft from the wheel bearing and hub. Support the halfshaft in a level position.
10. Remove and discard the strut-to-wheel knuckle nut and flagbolt.
^
To install, tighten to 175 Nm (129 lb-ft).
11. Remove the wheel knuckle.
^
If necessary, remove the wheel hub and bearing.
12. To install, reverse the removal procedure.
