Taurus FWD V6-3.5L (2008)
Rear Knuckle Alignment Link: Service and Repair
Toe Link
Toe Link
Removal and Installation
CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure may
result in major service expense. New parts must be installed with the same part numbers or equivalent part, if replacement is necessary. Do
not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure
correct retention of these parts.
1. Remove the wheel and tire.
2. Detach the wheel speed sensor wire from the toe link.
3. Remove and discard the toe link-to-wheel knuckle nut and bolt.
^
To install, tighten to 100 Nm (74 lb-ft).
4. Remove and discard the toe link-to-subframe nut and bolt.
^
To install, tighten to 100 Nm (74 lb-ft).
5. NOTE: Always install new suspension fasteners.
