Taurus FWD V6-3.5L (2008)
5. CAUTION: Install and tighten the new halfshaft nut to specification in a continuous rotation. Stopping the rotation during installation
will cause the nylon lock to seat incorrectly. This will cause incorrect torque readings while tightening the front axle wheel end nut and
lead to bearing failure. Always install a new front axle wheel end nut after loosening or when not tightened to specifications in a
continuous rotation.
CAUTION: Never use power tools to tighten the front axle wheel end nut or damage to the nut or wheel bearing may occur.
NOTE: Apply the brake to keep the halfshaft from rotating.
Install a new halfshaft nut.
^
Tighten to 350 Nm (258 lb-ft).
6. Install the front wheel.
7. Fill with clean automatic transmission fluid to the correct level.