Taurus X AWD V6-3.5L (2009)
10. If equipped, remove the door lock cylinder circlip and position the front door lock cylinder rod and pawl aside.
11. If equipped, remove the front door lock cylinder pawl from the actuating rod.
12. Open the yellow clip and disconnect the exterior door handle actuating rod from the front door latch.
13. Remove the 3 front door latch bolts.
14. Remove the 11 bolts and position the door module aside.
15. Disconnect the door ajar switch and the door lock actuator electrical connectors.
16. Disconnect the push button rod from the front door latch.
17. Remove the rain hat from the latch.
1. Remove the push pin.
2. Remove the rain hat.
18. Release the interior door handle cable from the latch.
19. Remove the front door latch from the bracket.
-
If necessary, remove the door lock actuator and the door ajar switch.
Installation
NOTE: If necessary, install the door ajar switch and the door lock actuator.
1. If equipped, position the door disarm switch and the door lock cylinder pawl on the door lock cylinder and install the circlip.
2. Install the front door latch on the bracket.
3. Connect the interior door handle cable to the latch.
4. Install the rain hat on the latch.
5. Connect the push button rod to the front door latch.
6. Connect the door ajar switch and the door lock actuator electrical connectors.
