Taurus X AWD V6-3.5L (2009)
2. Remove the tie strap retaining the unused pressure sensor electrical connector of the seat wiring harness.
20. Lift the foam pad, trim cover and bladder and move aside to access the seat track nuts.
-
When installing, make sure the safety belt buckle pretensioner is positioned through the seat cushion trim cover opening.
All seats
21. Remove the 4 nuts and the seat track.
-
To install, tighten to 33 Nm (24 lb-ft).
22. NOTE: The memory seat track position sensors are integral to the memory seat track motors. The memory seat track motor electrical connectors
will connect to a seat track without the memory option. Make sure the correct seat track is being installed.
To install, reverse the removal procedure.
23. Install the seat. For additional information, refer to Seat - Front See: Service and Repair/Front Seats/Seat - Front.
-
If a new seat track has been installed on a driver seat with memory, the seat must be operated in all directions through the full range of travel to
avoid a premature stopping point occurrence after the vehicle is returned to the customer.
24. Repower the SRS. If the passenger seat was serviced, do not prove out the SRS at this time. For additional information, refer to Supplemental
Restraint System (SRS) Depowering and Repowering in the General Procedures of Air Bag Systems.
Passenger seat
25. WARNING: Make sure the front passenger seat repair is complete, the seat and all attached components (head restraint, seat side shield,
etc.) are correctly assembled, and the seat is correctly installed to the vehicle before carrying out the System Reset. Failure to follow these
instructions may result in incorrect operation of the occupant classification sensor (OCS) system and increases the risk of serious
personal injury or death in a crash.
WARNING: Install a new occupant classification sensor (OCS) system service kit as a complete assembly. Never install only part of the
kit components. Failure to follow this instruction may result in incorrect operation of the OCS system and increases the risk of serious
personal injury or death in a crash.
NOTICE: To prevent system failure, the following precautions must be taken before carrying out the Occupant Classification Sensor
(OCS) system reset:
-
Make sure the voltage to the Occupant Classification System Module (OCSM) is above 8 volts and less than 18 volts.
-
Make sure the OCS system is not at a temperature below 6°C (42°F) or above 36°C (97°F) when initiating the OCS system reset
process. If the vehicle has been exposed to extreme cold or hot temperatures, the vehicle must be exposed and kept at a temperature
within the limits, 6°C to 36°C (42°F to 97°F) for a minimum of 30 minutes.
-
Make sure nothing is present on the passenger seat before carrying out the OCS system reset and nothing is placed on the seat during
the process.
-
Make sure a minimum 8-second time period has passed after cycling the ignition switch ON before the carrying out the OCS system
reset process.
Carry out the OCS system reset.
26. If the first system reset attempt was unsuccessful, carry out a thorough visual inspection of the following and repair any concerns found.
-
OCS system connector and wiring for damage
