ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Procedures|Page 1617 > < Procedures|Page 1615
Page 4
background image

18. Disconnect the vacuum hose and the Evaporative Emission (EVAP) tube from the upper intake manifold.

19. Detach the EVAP tube pin-type retainer from the upper intake manifold.

20. Disconnect the upper radiator hose, lower radiator hose and one heater hose from the thermostat housing.

21. Disconnect the transaxle control cable from the control lever.

22. Disconnect the transaxle control cable from the shift cable bracket.

23. If equipped, detach the engine block heater wiring harness from the radiator support and the power steering tube.

24. Disconnect the A/C pressure switch and remove the nut and disconnect the upper A/C tube from the condenser.

-

Discard the O-ring seal.

Procedures|Page 1617 > < Procedures|Page 1615