Taurus X AWD V6-3.5L (2009)
34. Install the engine mount bracket and the 2 bolts.
-
Tighten to 24 Nm (18 lb-ft).
35. NOTE: Apply clean engine oil to the crankshaft front seal bore in the engine front cover.
Using the Crankshaft Vibration Damper Installer and Front Crankshaft Seal Installer, install a new crankshaft front seal.
36. NOTE: Lubricate the outside diameter sealing surfaces with clean engine oil.
Using the Crankshaft Vibration Damper Installer and Front Cover Oil Seal Installer, install the crankshaft pulley.
37. Using the Strap Wrench, install the crankshaft pulley washer and new bolt and tighten in 4 stages.
-
Stage 1: Tighten to 120 Nm (89 lb-ft).
-
Stage 2: Loosen one full turn.
-
Stage 3: Tighten to 50 Nm (37 lb-ft).
-
Stage 4: Tighten an additional 90 degrees.
38. Install the accessory drive belt tensioner and the 3 bolts.
-
Tighten to 11 Nm (97 lb-in).
