ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Supplemental Restraint System (SRS) Depowering and Repowering|Page 7445 > < Supplemental Restraint System (SRS) Depowering and Repowering|Page 7443
Page 2
background image

auxiliary batteries and power supplies (if equipped).

Failure to follow these instructions may result in serious personal injury or death in the event of an accidental deployment.

Disconnect the battery ground cable and wait at least one minute.

7. Remove the driver air bag module. Refer to Driver Air Bag Module  See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Driver

Air Bag Module.

8. Open the glove compartment door.

9. Release the dampening strut from the LH side of glove compartment door and lower door fully.

10. NOTE: Taurus X shown, Taurus and Sable similar.

NOTE: RH shown, LH similar.

Through the glove compartment opening, disconnect the 2 passenger air bag module electrical connectors.

11. From under the rear of the passenger seat, slide and disengage the passenger seat side air bag module electrical connector locking clip, and then

release the tab and disconnect the passenger seat side air bag module electrical connector.

12. From under the rear of the driver seat, slide and disengage the driver seat side air bag module electrical connector locking clip, and then release

the tab and disconnect the driver seat side air bag module electrical connector.

Taurus X safety canopy modules

13. Release and position aside the driver side D-pillar trim panel.

14. NOTE: Headliner removed for clarity.

Disconnect the driver side safety canopy module electrical connector.

Supplemental Restraint System (SRS) Depowering and Repowering|Page 7445 > < Supplemental Restraint System (SRS) Depowering and Repowering|Page 7443