Taurus X AWD V6-3.5L (2009)
GO to K5.
No
GO to K6.
-------------------------------------------------
K5 CHECK THE STOPLAMP SWITCH OUTPUT CIRCUIT FOR A SHORT TO VOLTAGE
-
Disconnect: SJB C2280b.
-
Does the high mounted stoplamp continue to illuminate?
Yes
REPAIR circuit CCB08 (VT/WH) for a short to voltage. CLEAR the DTCs. REPEAT the self-test.
No
GO to K7.
-------------------------------------------------
K6 CHECK FOR CORRECT PCM OPERATION
-
Disconnect all the PCM connectors.
-
Check for:
-
corrosion
-
damaged pins
-
pushed-out pins
-
Connect all the PCM connectors and make sure they seat correctly.
-
Operate the system and verify the concern is still present.
-
Is the concern still present?
Yes
INSTALL a new PCM. TEST the system for normal operation.
No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector.
-------------------------------------------------
K7 CHECK FOR CORRECT SJB OPERATION
-
Disconnect all the SJB connectors.
-
Check for:
-
corrosion
-
damaged pins
-
pushed-out pins
-
Connect all the SJB connectors and make sure they seat correctly.
-
Operate the system and verify the concern is still present.
-
Is the concern still present?
Yes
INSTALL a new SJB. TEST the system for normal operation.
No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector.
-------------------------------------------------
