Taurus X AWD V6-3.5L (2009)
2. Remove the pressure line bracket-to-rear engine bolt.
-
To install, tighten to 9 Nm (80 lb-in).
3. Disconnect the Power Steering Pressure (PSP) switch electrical connector from the pressure line.
4. Remove the pressure line bracket-to-valve cover stud nut.
-
To install, tighten to 9 Nm (80 lb-in).
5. Remove the pressure line bracket-to-steering gear bolt.
-
To install, tighten to 23 Nm (17 lb-ft).
6. Remove the power steering line clamp plate bolt.
-
Rotate the clamp plate and disconnect the pressure line from the steering gear.
-
To install, tighten to 23 Nm (17 lb-ft).
7. To install, reverse the removal procedure.