Taurus X AWD V6-3.5L (2009)
-
Are the voltages greater than 10 volts?
Yes
GO to C3.
No
VERIFY the SJB fuses 26 (10A) or 29 (5A) are OK. If OK, REPAIR the circuit in question. If not OK, Refer to the Wiring Diagrams to identify the
possible causes of the short circuit. CLEAR the DTCs. REPEAT the network test with the scan tool.
-------------------------------------------------
C3 CHECK THE IC GROUND CIRCUITS
-
Ignition OFF.
-
Measure the resistance between the IC, harness side and ground as follows:
-
Are the resistances less than 5 ohms?
Yes
GO to C4.
No
REPAIR the circuit in question. CLEAR the DTCs. REPEAT the network test with the scan tool.
-------------------------------------------------
C4 CHECK THE HS-CAN CIRCUITS BETWEEN THE IC AND THE DATA LINK CONNECTOR (DLC) FOR AN OPEN
-
Measure the resistance between the IC C220-7, circuit VDB04 (WH/BU), harness side and the DLC C251-6, circuit VDB04 (WH/BU), harness
side.
