Taurus X AWD V6-3.5L (2009)
-
Is the resistance less than 5 ohms?
Yes
GO to M3.
No
REPAIR the circuit. CLEAR the DTCs. REPEAT the network test with the scan tool.
-------------------------------------------------
M3 CHECK THE MS-CAN CIRCUITS BETWEEN THE SDARS MODULE AND THE DATA LINK CONNECTOR (DLC) FOR AN OPEN
-
Measure the resistance between the SDARS module C4344-1, circuit VDB06 (GY/OG), harness side and the DLC C251-3, circuit VDB06
(GY/OG), harness side.
-
Measure the resistance between the SDARS module C4344-7, circuit VDB07 (VT/OG), harness side and the DLC C251-11, circuit VDB07
(VT/OG), harness side.
-
Are the resistances less than 5 ohms?
Yes
GO to M4.
No
REPAIR the circuit. CLEAR the DTCs. REPEAT the network test with the scan tool.
-------------------------------------------------
M4 CHECK FOR CORRECT SDARS MODULE OPERATION
-
Disconnect the SDARS module connector.
-
Check for:
-
corrosion
-
damaged pins
-
pushed-out pins
-
Connect the SDARS module connector and make sure it seats correctly.
-
Operate the system and verify the concern is still present.
-
Is the concern still present?
