Taurus X AWD V6-3.5L (2009)
NOTE: When re-running the network test, the network test application must be first closed or the screen display will revert back to the prior run network
test results.
-
Disconnect: SJB Fuse 3 (15A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuse. For vehicles equipped with 2 or more of the following modules: APIM, RETM or SDARS module, GO to T14.
For vehicles equipped with an APIM only, Go To Pinpoint Test O. See: Pinpoint Test O: The Accessory Protocol Interface Module (APIM) Does Not
Respond To The Scan Tool
For vehicles equipped with a RETM only, Go To Pinpoint Test K. See: Pinpoint Test K: The Rear Entertainment Module (RETM) Does Not Respond
To The Scan Tool
For vehicles equipped with a SDARS module only, Go To Pinpoint Test M. See: Pinpoint Test M: The Satellite Digital Audio Receiver System
(SDARS) Module Does Not Respond To The Scan Tool
No
INSTALL the removed fuse. GO to T17.
-------------------------------------------------
T14 VERIFY VEHICLE EQUIPMENT - APIM
-
Inspect the vehicle for an APIM.
-
Is the vehicle equipped with an APIM?
Yes
GO to T15.
No
GO to T16.
-------------------------------------------------
T15 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE APIM DISCONNECTED
NOTE: When re-running the network test, the network test application must be first closed or the screen display will revert back to the prior run network
test results.
-
Disconnect: APIM C3342.
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
CONNECT the APIM. Go To Pinpoint Test O. See: Pinpoint Test O: The Accessory Protocol Interface Module (APIM) Does Not Respond To The
Scan Tool
No
CONNECT the APIM. If the vehicle is equipped with a RETM, Go To Pinpoint Test K. See: Pinpoint Test K: The Rear Entertainment Module (RETM)
Does Not Respond To The Scan Tool
Otherwise, Go To Pinpoint Test M. See: Pinpoint Test M: The Satellite Digital Audio Receiver System (SDARS) Module Does Not Respond To The
Scan Tool
-------------------------------------------------
T16 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE RETM DISCONNECTED
