Taurus X AWD V6-3.5L (2009)
PROM - Programmable Read Only Memory: All Technical Service Bulletins
Engine Controls - Harsh Low Speed Driveline Clunks
TSB 08-26-13
01/05/09
HARSH DRIVELINE CLUNK FELT AT LOW SPEED -
BELOW 10 MPH (16 KM/H) - STOP AND GO DRIVING
ON TIP-IN (COULD BE PERCEIVED AS A HARSH 1-2
UPSHIFT OR 2-1 DOWNSHIFT)
FORD:
2008-2009 Taurus X, Taurus, Edge
LINCOLN:
2008-2009 MKX
MERCURY:
2008-2009 Sable
This article supersedes TSB 08-23-16 to update the vehicle lines and issue statement.
ISSUE
Some 2008-2009 Taurus, Taurus X, Sable vehicles built before 10/15/2008, and 2008-2009 Edge and MKX vehicles built before 11/20/2008 may
exhibit a harsh driveline clunk at low speed, below 10 MPH (16 Km/h) during stop and go driving on tip-in may be due to a Powertrain Control Module
(PCM) calibration. There is a new calibration that will improve the low speed stop and go driving feel.
ACTION
Reprogram the PCM to the latest calibration using IDS release 57.10 and higher or 58.1 and higher. This new calibration is not included in the VCM
2008.11 DVD. Calibration files may also be obtained at the website.
NOTE
THIS NEW CALIBRATION WAS IMPLEMENTED IN PRODUCTION ON OCTOBER 15, 2008 FOR THE 2009 MODEL YEAR TAURUS,
TAURUS X, SABLE VEHICLES, AND ON NOVEMBER 20, 2008 FOR THE 2009 MODEL YEAR EDGE, MKX VEHICLES, THIS
PROCEDURE DOES NOT APPLY TO ANY VEHICLE BUILT AFTER THOSE DATES.
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.
OPERATION
DESCRIPTION
TIME
082613A
2008-2009 Edge, MKX,
0.3 Hr.
Taurus, Taurus X, Sable:
Check For DTCs And
Reprogram The PCM.
Authorization Decal Not
Required (Do Not Use
With 12650D)
DEALER CODING
CONDITION
BASIC PART NO.
CODE
RECAL
04
Disclaimer
