Taurus X AWD V6-3.5L (2009)
2. WARNING: Install a new occupant classification sensor (OCS) system service kit as a complete assembly. Never install only part of the
kit components. Failure to follow this instruction may result in incorrect operation of the OCS system and increases the risk of serious
personal injury or death in a crash.
NOTICE: Failure to route the Occupant Classification Sensor (OCS) system components through the correct seat cushion support
opening may cause component failure.
NOTICE: While positioning the seat cushion frame and Occupant Classification Sensor (OCS) system assembly, be careful not to damage
any of the components. Failure to do so may result in component failure.
Position the OCS system assembly to the seat cushion frame.
-
Slide the pushpin clip retainer onto the double header connector.
-
Connect the double header connector to the 18-way connector on the OCS system service kit harness.
-
Feed the OCSM, electrical connector, wire harness, pressure sensor and hose through the largest opening at the front of the seat cushion frame
support assembly.
-
Position the seat cushion pad and bladder to the seat cushion frame and install the OCS system bladder pin-type retainers.
3. NOTE: When installing a new OCS, the main seat wire harness pressure sensor electrical connector is not used.
NOTE: The OCSM must be correctly positioned and securely riveted in place. Failure to do so may set a DTC in the RCM.
Attach and connect the OCS components.
-
Position the OCSM onto the seat cushion frame bracket and install new rivets.
-
Install the pressure sensor onto the seat cushion frame bracket, making sure the retaining tab is completely engaged.
-
Make sure the pressure sensor hose is routed correctly and is not kinked during installation.
-
When installed correctly, an audible click will be heard and the pressure sensor will not be able to be removed from its bracket without
disengaging the retaining tab.
-
Connect the main seat wire harness OCS electrical connector to the OCS service kit electrical connector, and then attach the connector
pin-type retainer to the seat track bracket.
-
Tie strap the wire harness and electrical connector safely aside.
-
Using electrical tape, tape the OCS service kit wire harness to the pressure sensor hose.
-
Do not tie strap the OCS service kit wire harness to the pressure sensor hose.
4. Align the seat cushion trim cover to the seat cushion foam pad and attach the hog rings.
