ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Seat Position Sensor > < Occupant Classification Sensor - Original Equipment|Page 5824
Page 5
background image

-

remain lit continuously.

-

flash.

The flashing might not occur until approximately 30 seconds after the ignition switch has been turned from the OFF to the ON position. This is the
time required for the RCM to complete the testing of the SRS. If the air bag warning indicator is inoperative and a SRS fault exists, a chime will
sound in a pattern of 5 sets of 5 beeps. If this occurs, the air bag warning indicator and any SRS fault discovered must be diagnosed and repaired.

Clear all continuous DTCs from the RCM and OCSM using a scan tool.

16. NOTE: When installing a new OCS system, a prepaid return postcard is provided. The serial number for the new part and the Vehicle

Identification Number (VIN) must be recorded and sent to Ford Motor Company.

If a new OCS system was installed, fill out the necessary information on the post card and return it along with the complete inoperative OCS to
Ford Motor Company.
-

When returning the inoperative OCS system include: seat cushion foam pad, bladder, OCSM, pressure sensor (transducer), hose, electrical
connectors and wire harness.

Seat Position Sensor > < Occupant Classification Sensor - Original Equipment|Page 5824