Taurus X AWD V6-3.5L (2009)
Drive/Propeller Shaft: Removal and Replacement
Driveshaft
Driveshaft
Removal and Installation
NOTE: Index-mark both driveshaft flanges.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the muffler and tailpipe.
3. Remove the 4 exhaust support brace bolts and the exhaust brace.
-
To install, tighten to 30 Nm (22 lb-ft).
4. NOTICE: Do not reuse the bolt and washer assemblies for the rear constant velocity (CV) joint flange. Install new assemblies or damage
to the vehicle may occur.
Remove and discard the 3 pinion flange bolt and washer assemblies.
-
To install, tighten to 25 Nm (18 lb-ft).