Taurus X AWD V6-3.5L (2009)
2. Using the Manual Lever Retaining Pin Installer, install a new TR sensor locking pin.
3. NOTE: If cleaning the main control assembly or inspecting the valves, refer to Identification Tags. If installing a new main control assembly,
continue with this procedure. See: Automatic Transmission/Transaxle/Application and ID
NOTE: Make sure that the manual pin (part of the TR sensor) is correctly installed in the manual valve.
Position the TSS, OSS and TR sensor wiring harnesses aside and install the main control valve body.
4. Inspect the manual pin to make sure it is correctly installed in the manual valve. If it is not, pull the valve body off the transaxle case. Correctly
install the manual pin in the manual valve and position the valve body in place.
5. Install the TR sensor detent spring and the 10 bolts. Tighten the bolts in the sequence shown.
-
Tighten to 12 Nm (106 lb-in).
