Taurus X FWD V6-3.5L (2008)
Assembly
Heated seats
1. CAUTION: If installing a new cushion foam pad, the heater mat cannot be reused. A new heater mat must be installed. Failure to follow
this instruction may result in component or system failure.
NOTE: A new heater mat can be attached to the foam pad where the old heater mat was removed but a used heater mat should not be reattached
to any foam pad.
Seats receiving a new OCS system service kit, install the new cushion heater mat onto the new cushion foam pad.
All seats
2. Position the cushion trim cover to the cushion foam pad and install the hog rings.
3. Install the seat wire harness.
Seats with manual recline
4. Position the manual recliner and drive the 2 large roll pins into the cushion frame and through the front manual recliner eyelets.
Seats with power recline
5. Position the power recliner to the cushion frame and install the 3 bolts.
-
Tighten to 10 Nm (89 lb-in).
6. Drive the 2 large roll pins into the cushion frame and through the front power recliner eyelets.
7. Connect the power recliner electrical connector.
Heated seats
8. Slide the heated seat module onto the bracket, making sure it is locked in place and install the rivet. Connect the heated seat module electrical
connector.
Seats with an OCS system service kit
9. WARNING: Make sure the front passenger seat repair is complete, the seat and all attached components (head restraint, seat side shield,
etc.) are correctly assembled, and the seat is correctly installed to the vehicle before carrying out the System Reset. Failure to follow these
instructions may result in incorrect operation of the occupant classification sensor (OCS) system and increases the risk of serious
personal injury or death in a crash.
CAUTION:
-
Inspect the occupant classification sensor (OCS) assembly, seat cushion frame and support assembly for any foreign objects before
installing the OCS assembly to the seat cushion frame. If any foreign objects are found, remove them. Failure to follow these
instructions may result in incorrect OCS system operation or failure.
-
Failure to route the occupant classification sensor (OCS) system components through the correct seat cushion support opening may
cause component failure.
NOTE: If the original equipment (OE) occupant classification sensor (OCS) system is not being installed, install an OCS system service kit using
all parts in the kit.
Position the OCS system to the seat cushion frame.
-
Using an OCS system service kit, feed the OCSM, electrical connector, wire harness, pressure sensor and hose through the largest opening at
the front of the seat cushion frame support assembly.
-
Position the seat cushion pad and bladder to the seat cushion frame.
