Taurus X FWD V6-3.5L (2008)
85. NOTE: RH shown, LH similar.
Install new upper stabilizer bar link nuts.
^
Tighten to 55 Nm (41 lb-ft).
86. CAUTION: Install and tighten the new front axle wheel end nut to specification in a continuous rotation. Stopping the rotation during
installation will cause the nylon lock to seat incorrectly. This will cause incorrect torque readings while tightening the front axle wheel
end nut and lead to bearing failure. Always install a new front axle wheel end nut after loosening or when not tightened to specifications
in a continuous rotation.
NOTE: Never use power tools to tighten the front axle wheel end nut.
NOTE: Apply the brake to keep the halfshaft from rotating.
Install the new halfshaft nut.
^
Tighten to 350 Nm (258 lb-ft).
87. Install the 2 engine roll restrictor-to-transaxle bolts.
^
Tighten to 103 Nm (76 lb-ft).
