Taurus X FWD V6-3.5L (2008)
Using the special tools, install a new crankshaft front seal.
16. NOTE: Lubricate the outside diameter sealing surfaces with clean engine oil.
Using the special tools, install the crankshaft pulley.
17. Using the special tool, install the crankshaft pulley washer and new bolt and tighten in 4 stages.
^
Stage 1: Tighten to 120 Nm (89 lb-ft).
^
Stage 2: Loosen one full turn.
^
Stage 3: Tighten to 50 Nm (37 lb-ft).
^
Stage 4: Tighten an additional 90 degrees.
18. NOTE: Installation of new seals is only required if damaged seals were removed during disassembly of the engine.
NOTE: Spark plug tube seal installation shown, variable camshaft timing (VCT) seal installation similar.
Using the special tools, install new VCT solenoid and/or spark plug tube seals.
