Taurus X FWD V6-3.5L (2008)
11. Loosen the A-pillar front door window glass clamp bolt.
-
To install, tighten to 8 Nm (71 lb-in).
12. Tape the window in position, then lower the window regulator downward until it reaches the stops at the bottom of the regulator tracks.
13. Remove the 11 bolts from the door module.
-
To install, tighten to 8 Nm (71 lb-in).
14. Remove the 3 door latch screws.
-
To install, tighten to 12 Nm (9 lb-ft).
15. Disconnect the 6 wiring harness retainers and the 2 connector retainers from the inside of the door module, then feed the wiring harness through
the door module.
