Tempo L4-140 2.3L CFI (1985)
Attach Engine Lifting Bracket (D81L-6001-D) or equivalent to points shown in Figure 1 with bolt (M10x1.5x2O).
6.
Remove belt tensioner.
7.
Remove engine mount.
8.
Remove idler pulley.
9.
Remove idler pulley bracket.
10.
Raise vehicle.
11.
Remove retaining bolts to stabilizer bar bracket.
12.
Lower vehicle.
13.
Lower engine assembly.
14.
Raise the vehicle to a height where damper can be removed easily.
15.
Remove damper bolt.
16.
Remove damper. (If necessary, use Puller-Differential Side Bearing Tool # T77F-4220-B1).
17.
Remove the front cover oil seal from the front cover (Front Cover Seal Tool # T74P-6700-A).
Front Cover Seal - Installation
1.
Coat new seal with long life lubricant (XG-1-C) (ESA-M1C75-B) or equivalent.
2.
Using Pinion Seal Replacer (T83T-4676-A), install the seal into cover.
a.
Drive the seal until it is fully seated.
b.
Check seal to ensure it is positioned properly.
3.
Install damper.
4.
Install damper bolt.
5.
Lower vehicle.
6.
Raise engine assembly.
7.
Raise vehicle.
8.
Install retaining bolts to stabilizer bar brackets.
9.
Lower vehicle.
10.
Install idler pulley bracket.
11.
Install idler pulley.
12.
Install engine mounts.
13.
Install belt tensioner.
14.
Remove engine support bar.
15.
Install fuel line shield.
16.
Install drive belt.
