Tempo L4-140 2.3L CFI (1985)
Figure 23
14.
Refer to Figure 23.
Raise jack, Rotunda Number 014-00210, to allow clearance for bearing retainer removal. Remove bearing retainer and shims while supporting
differential.
Figure 24
15.
Refer to Figure 24.
Move differential assembly to the left to clear differential bearing and remove from transmission case.
Differential Installation
NOTE:
If the differential case, bearing retainer or differential bearing is replaced, re-shimming will be required. Consult the appropriate Powertrain
Car Shop Manual, Section 15-20.
1.
Position the jack under the rear oil pan rail of transaxle case. Place a wood block between jack and case to protect oil pan and case mating surface.
CAUTION: Extreme care must be taken not to damage transaxle case.
2.
Raise the jack high enough to allow installation of bearing retainer.
NOTE:
Inspect both differential seals for any evidence of damage and replace, if necessary, prior to differential installation.