ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

All Technical Service Bulletins for Stabilizer Bushing:|8689 > < Front/Rear Stabilizer Bar Bushings - Squeak/Grunt Noise|Page 7185
Page 1
background image

Stabilizer Bushing: All Technical Service Bulletins
Front Suspension - Grunting Noise On Bumps

Article No. 

NOISE - "GRUNT" - FRONT SUSPENSION

87-7-8

VEHICLES BUILT PRIOR TO 11/17/86

FORD:

1986-87 ESCORT, EXP, TEMPO

LINCOLN-MERCURY: 1986-87 LYNX, TOPAZ

ISSUE:

A dry rubbing "grunt" noise may be heard when the front end of the vehicle goes over rough roads, speed bumps, driveways, etc. The noise
may be coming from either the stabilizer bar mount insulator(s) or the power steering gear inner tie rod joint(s).

ACTION:

To correct this, use the following service diagnostic procedure.

Diagnostics

Jolt or bounce front end of vehicle, by hand, a distance of four to six inches to confirm noise.

Attempt to isolate noise source by touching tie rod and stabilizer bar (near body insulators) to feel for vibrations caused by friction during bounce and
rebound.

Vibrations, in either component, identify that as the possible causal part.

If the tie rods are the suspected component, confirm this noise source by disconnecting them at knuckle attachment and again jolt or bounce vehicle front
end to see if noise disappears.

Service Procedure

If noise is caused by tie rods, replace them with new tie rod assemblies (E7FZ-3280-A). Refer to Section 13-46-12 of the appropriate Car Shop Manual.

NOTE:

The tie rod noise condition applies only to vehicles built between February 24, 1986 and November 17, 1986.

If noise is caused by stabilizer bar, follow the service procedures outlined in TSB Article No. 86-8-9, dated April 23, 1986.

NOTE:

Only use the lubricant (E25Y-19553-A) specified in TSB 86-8-9. Use of other types of lubricants will result in a repeat repair.

NOTE:

Beginning with Job #1, 1987 model year, all front stabilizer insulators are pregreased and should not require additional greasing.

PART NUMBER

PART NAME

CLASS

E7FZ-3280-A

Tie Rod Assembly

B

OTHER APPLICABLE ARTICLES: 86-8-9
WARRANTY STATUS: Reimbursable within the provisions of the Warranty and Policy Manual
OPERATION: SP870708A
TIME:

3.0 Hrs. - Escort/Lynx, EXP 
2.7 Hrs. - Tempo/Topaz 

DLR. CODING: Basic Part No. 3280 - Code: 56

All Technical Service Bulletins for Stabilizer Bushing:|8689 > < Front/Rear Stabilizer Bar Bushings - Squeak/Grunt Noise|Page 7185