Tempo L4-140 2.3L HSC (1986)
Figure 29
3.
Place a jack stand under the engine and carefully lift just enough to remove tension on the rubber engine mounts. Loosen the front and rear engine
mounts (Figures 27 and 28) and the rear shifter-tobody mounts (Figure 29). Move the engine as far forward as the slots in the engine mounts allow.
Retighten the engine mounts in the following order: 1, 3A and then 4, and the shifter mounts.
Figure 30
4.
Remove the detent plunger retainer screw Figure 30). Leakage from the transaxle will occur when removing the detent plunger screw. To minimize
oil leakage, plug hole with your finger until you are ready to replace retainer screw with E6FZ-7233-A Kit - Transmission Detent Plunger and
Spring.
NOTE:
If excessive amount of oil has leaked out, check transaxle fluid level after installation of cartridge assembly.
