Tempo V6-182 3.0L (1993)
Ignition Rotor: Service and Repair
DISTRIBUTOR CAP
Removal
1.
Loosen the distributor cap hold down screws.
2.
Lift the cap straight up to avoid damage to the distributor rotor blade and spring.
Installation
1.
Position the distributor cap over the distributor, aligning the position of the attaching screws with the screw holes on the distributor.
2.
Tighten the hold down screws to 18-23 in-lb.
3.
Reinstall any ignition wires that were removed, noting their correct locations on the distributor cap.
ROTOR
Removal
With the distributor cap removed, pull rotor upward to remove it from the distributor shaft.
Installation
Align location boss on rotor with hole on armature. Fully seat rotor on the distributor shaft.
