Tempo V6-182 3.0L (1993)
-
If gauge peg does not go through, proceed with next smaller gauge peg for Go/No-Go Test.
NOTE: It is important that the largest Go/No-Go combination is used in determining the proper plug size.
4.
If the smallest gauge peg does not go through the orifice, use reamer bit and handle included with service kit, to enlarge throttle plate orifice. Wipe
bearing grease on both sides of the plate orifice and on reamer bit to hold the brass chips. After reaming, wipe throttle plate clean, then return to
Step 3 to determine proper orifice plug size.
5.
Use the installation tool from service kit, push plug into orifice until it bottoms out in throttle plate.
6.
Open and snap shut the throttle several times to verify proper plug retention.
7.
Reconnect air inlet tube(s).
8.
Reset idle rpm per engine requirement, using throttle plate stop screw.
