Tempo V6-182 3.0L (1993)
Air Bag(s) Arming and Disarming: Service and Repair
Arming and Disarming
Deactivation Procedure
1. Disconnect positive battery cable.
2. Wait one minute. This is the time required for backup power supply in diagnostic monitor to deplete its stored energy.
3. Remove four nut and washer assemblies retaining driver air bag module to steering wheel.
4. Disconnect driver air bag connector.
5. Connect Rotunda Air Bag Simulator 105-00010 or equivalent to vehicle harness at top of steering wheel.
6. Connect positive battery cable.
Reactivation Procedure
WARNING: THE AIR BAG SIMULATOR(S) MUST BE REMOVED AND THE AIR BAG(S) RECONNECTED WHEN THE SYSTEM IS
REACTIVATED.
1. Disconnect positive battery cable.
2. Wait one minute for backup power supply to deplete stored energy.
3. Remove air bag simulator from vehicle harness connector at top of steering column. Reconnect driver air bag connector. Position driver air bag on
steering wheel and secure with four nut and washer assemblies (10 mm). Tighten nut and washer assemblies to 2.7-3.7 Nm (24-32 lb-in).
4. Connect positive battery cable.
5. Prove-out system.