Tempo V6-182 3.0L (1993)
Wheel Bearing: Adjustments
1.
Raise and support vehicle. Remove dust cover from hub. Remove wheel assembly, if necessary.
2.
Remove cotter pin and nut retainer.
3.
Back off adjusting nut 1 full turn.
Rear Wheel Bearing Assembly
4.
Torque adjusting nut to 17-25 ft lb while rotating drum assembly.
5.
Back off adjusting nut 1/2 turn, then retighten adjusting nut to 10-15 in lb. Position adjusting nut retainer over nut so slots are aligned with cotter
pin hole, then install cotter pin.
6.
Install dust cover and wheel assembly and lower vehicle to ground.