ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Windnoise - Diagnosis and Service Procedures|Page 8605 > < Windnoise - Diagnosis and Service Procedures|Page 8603
Page 14
background image

Figure 19

Correction:

Pull flocked run out of the corner of door frame and install a piece of 1/8"x7/8"x2" long foam tape as shown in Figure 19.

Group III Rear Doors Tempo/Topaz

1.

Concern: A gap exists between the belt moulding and the door at front of rear door.

Figure 20

Correction:

Remove belt moulding and apply two layers of 1/4"x3/4"x6" long foam tape to the underside of the belt moulding as shown in Figure
20.

2.

Concern: Early built units did not include a foam gasket behind the sail cover area on low series vehicles.

NOTE:

On low series vehicles the sail cover is an integral part of the door trim panel.

Windnoise - Diagnosis and Service Procedures|Page 8605 > < Windnoise - Diagnosis and Service Procedures|Page 8603