Thunderbird L4-140 2.3L SOHC Turbo (1984)
Figure 10
8.
Cut the oil cooler outlet tube at the left rear corner of the engine (Figure 10) and discard the tube end and outlet hose. Do not remove the section of
the oil cooler outlet tube that is clamped to the rear of the engine.
Figure 11
Installation
1.
Install the oil cooler hose bracket (E5RY-6K759-A) under the engine rocker cover left rear attaching screw (Figure 11).
2.
Position clamp (378042-S) onto the oil cooler outlet hose (E5ZZ-18472-A) as shown in Figure 11. Then position the outlet hose over the engine
rocker cover and down the left side of the engine to the oil cooler (Figure 11). Connect the hose to the oil cooler, but do not tighten the hose clamp
.
3.
Attach clamp (378042-S) to the bracket installed on the left rear corner of the rocker cover with screw (E-610888-S71). After the hose is secured
with the clamp, route the temperature sending unit wire under the hose and connect it to the sending unit.
