ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Ignition System Resistance - Manual Revision|Page 415 > < Ignition System Resistance - Manual Revision|Page 413
Page 1
background image

Ignition Control Module: Description and Operation

Thick Film Ignition Module

  The TFI IV ignition module, Fig. 14, has six connector pins at the wiring harness that supplies the following signals:

Run
Crank (start)
Tach (coil)
PIP (crankshaft position to ECA)
Spark output (SPOUT from ECA)
Internal ground from the ECA to the distributor

 

Ignition System

The TFI IV module supplies the spark to the distributor through the ignition coil and calculates the duration. It receives its control signal from the ECA
(SPOUT) Fig. 29.

NOTE: Some later models use a remote module (Closed Bowl Distributors/CBD). It is located in the engine compartment (Refer to
"COMPONENT LOCATIONS"). The operation is essentially the same with the exception of the CBD has a wiring harness between the
ignition module and the distributor.

Ignition System Resistance - Manual Revision|Page 415 > < Ignition System Resistance - Manual Revision|Page 413