ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Hazard Warning Switch > < Glove Compartment Lamp - Battery Drain
Page 1
background image

Glove Box Lamp Switch: All Technical Service Bulletins
Glove Compartment Lamp - Battery Drain

Article No. 84-4-2

INSTRUMENT PANEL - GLOVE COMPARTMENT - LIGHT REMAINS ON WHEN DOOR IS CLOSED

FORD 1983-84 THUNDERBIRD

LINCOLN-MERCURY 1983-84 COUGAR

FIGURE 6

If a battery drain or no start condition is encountered, it may be caused by the glove compartment door not depressing the glove compartment light
switch plunger far enough to shut off the light. To service, add a shim to the glove box as outlined in the following procedure and Figure 6.
1.

Open glove compartment.

2.

Remove (2) buttons from the glove compartment stops allowing glove compartment to rotate outward beyond the normal position.

3.

Fabricate a shim 1/8" thick x 1-1/2" square using a hard material (plastic, metal, etc.) and cement to glove box (rear side) with D7AZ-19B508-A
adhesive or equivalent.

4.

Reposition glove compartment and install (2) buttons retaining stops to glove compartment.

5.

Close glove compartment and verify light is working properly.

OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: Reimbursable within the provisions of the Warranty and Policy Manual.
OPERATION: SP06010A84
TIME:

0.3 Hr. DLR. CODING: Basic Part No. 06010 Code: 36

Hazard Warning Switch > < Glove Compartment Lamp - Battery Drain