Thunderbird V6-232 3.8L SC (1989)
Figure 2
3.
Remove ten (10) screws holding the cowl top leaf screens, Figure 2. Carefully position the left hand screen on the windshield out of the way.
NOTE:
IT IS NOT NECESSARY TO DISCONNECT THE WASHER HOSES ON THE LEFT HAND SIDE.
4.
Remove and throw away the right hand screen.
5.
Apply black silicone rubber sealer (D6AZ-19562-BA) to the upper cowl body seam behind the A/C air inlet.
a.
A continuous bead of sealer must be applied to the rear cowl body seam around the right corner and up the right seam to the cowl drain, near
the edge of the hood hinge.
b.
Inspect the seal between the air inlet and cowl surface. Apply sealer as required to assure a water tight seal.
Figure 3
