Thunderbird V6-232 3.8L SC (1989)
5.
Feed the wire through the new holes in the seat track cover as shown in Figure 3 and twist the wire ends until the cover is fully secured to the seat
track assembly.
6.
Trim the excess wire leaving 1/2" (12.7 mm) of twisted wire. Refer to Figure 4.
7.
Bend the remaining 1/2" (12.7 mm) of twisted wire upward, positioning it behind the shield and flush to the rivet as shown in Figure 4. This keeps
the wire from interfering with the operation of the seat track assembly and avoids possible customer contact.
