Thunderbird V6-232 3.8L SC (1989)
Cruise Control Brush Assembly: Service and Repair
Speed Control/Horn Brush Contact Plate
1.
Pull upward on upper middle edge of the horn cover/pad assembly and separate it from the steering wheel.
2.
Disconnect horn switch electrical connectors from horn cover/pad assembly, then set the assembly aside.
3.
Disconnect electrical connector from the speed control/horn brush contact plate terminal.
4.
Remove and discard steering wheel attaching nut.
5.
Using a puller, remove steering wheel from shaft. To prevent damage never hit steering wheel attaching bolt or use a knock-off type steering
wheel puller.
6.
Working from back side of steering wheel, remove three retaining screws, then the speed control/horn brush contact plate.
7.
Reverse procedure to install.