Thunderbird V6-232 3.8L SC (1989)
9.
If necessary obtain and cut a new 3-inch piece of hose (E1PZ-9324-C). Connect hose to fuel vapor valve assembly and to vent tube line. Make
sure that the rollover valve assembly and grommet are seated properly.
CAUTION:
While raising the tank into position, make sure that the fuel vent crossover hose is positioned above the vent retainer and is not contacting the drive shaft.
(Figure 3).
10.
Raise fuel tank.
11.
Connect fuel tank hoses to fuel filler pipe (Figure 1).
12.
Tighten clamps from hoses to fuel filler pipe.
13.
Install fuel tank straps and four fuel tank strap bolts. Tighten bolts to 28-40 N-m (21-29 lb.ft.).
14.
Install screws to exhaust shield.
15.
fnstall cross-over support.
16.
Prepare and install Authorized Modifications Decal.
Modifications Decal
AUTHORIZED MODIFICATIONS DECAL
Insert your P & A Code, "Vapor Return Hose Inspected and, if necessary, Reconnected/Replaced", "Emissions Recall 92E22" and date and attach the
Authorized Modifications Decal to a clean surface on the fan shroud.
Place the clear overlay on the decal.
EMISSIONS RECALL - PROOF OF CORRECTION CERTIFICATE
