Thunderbird V6-232 3.8L SC (1989)
13.
Remove steering shaft assembly from top end of column.
14.
Remove two lock cylinder housing-to-outer tube retaining bolts.
Installation
1.
Position lock cylinder housing onto upper steering flange bracket. Install and torque two lock cylinder housing-to-bracket retaining bolts to 12-20
ft. lbs.
2.
Install steering shaft assembly through lock cylinder housing top hole, into column tube and through the lower bearing. Use caution not to damage
the bearing.
3.
Ensure tilt spring is properly positioned, then install upper casting assembly over the shaft and down into lock cylinder housing ears. Ensure lock
lever is latched in the top tilt position.
4.
Align the tilt castings, then using a C-clamp install two pivot pins until flush with casting surface.
5.
Install upper bearing snap ring and retainer plate.
6.
Install conical coil spring by snapping it into shaft groove.
7.
Install multi-function switch.
8.
Install lower bearing sleeve, sensor ring, spring and new spring retainer.
9.
If equipped, install sensor switch and sensor ring shield.
10.
Install U-joint assembly. Torque attaching bolt to 30-42 ft. lbs.
11.
Install steering column as described previously.
