Thunderbird V6-232 3.8L SC (1989)
Fig. 5 Steering Column Exploded View
Refer to Figs. 4 and 5 for component identification.
Removal
1.
Remove steering column as described previously.
2.
Remove two screws retaining multi-function switch, then the switch.
3.
Remove conical coil spring and upper bearing retainer plate.
4.
Remove shaft C-clip at top of bearing.
5.
Set tilt casting in the upper position.
6.
Using Pivot Pin Remover Handle tool No. T67P-3D739-C and Pivot Pin Remover tools No. T67P-3D739-B or equivalent, carefully remove pivot
pins. Use caution when removing pivot pins, they are under pressure and will expand with force.
7.
Remove upper tilt casting from lock cylinder over end of shaft.
8.
Separate U-joint from lower end of shaft.
9.
If equipped remove sensor ring shield, two sensor switch retaining screws, then the switch.
10.
Remove and discard spring retainer.
11.
Remove spring and sensor ring.
12.
Using a suitable tool, remove shaft bearing sleeve.
