Thunderbird V8-281 4.6L SOHC (1994)
17.
Disconnect stop lamp switch, Figure 2.
18.
Pull back the floor carpet as required on the RH and LH sides of the vehicle and disconnect the window regulator safety switch connector and the
Powertrain Control Module connector.
19.
Remove glove compartment:
a.
Open glove compartment to the stop.
b.
Unsnap the hydraulic lift from the right side of the glove compartment.
c.
Remove the three (3) screws at the bottom retaining the glove compartment door hinge and glove compartment to the instrument panel.
d.
Remove glove compartment from the instrument panel.
20.
Reach through the glove compartment opening and disconnect the electrical and vacuum connectors from the heater-A/C evaporator housing.
21.
Disconnect the connectors behind the RH kick panel, Figure 3.
22.
Disconnect the two (2) speed control amplifier connectors.
