Thunderbird V8-281 4.6L SOHC (1994)
Crankshaft Position Sensor: Service and Repair
Crankshaft Position Sensor Assembly
REMOVE
1. Disconnect negative battery cable.
2. Remove serpentine belt.
3. Raise vehicle and support with jackstands.
4. Disconnect Crankshaft Position (CKP) sensor and A/C compressor electrical connectors from the engine wiring harness.
5. Discharge the A/C system and remove the A/C compressor.
6. Remove the CKP sensor retaining screw and sensor.
INSTALL
1. Make sure the CKP sensor mounting surface is clean and sensor O-ring is in proper location on the assembly.
2. Position CKP sensor assembly and install the retaining screw. Tighten to 8-12 Nm (71-106 in lb).
CAUTION: Do not overtighten the screw.
3. Install the A/C compressor. Evacuate and recharge the A/C system.
4. Properly route the engine wiring harness and connect the electrical connectors to the A/C compressor and crankshaft sensor.
5. Lower the vehicle.
6. Install the serpentine belt.
7. Connect the negative battery cable.
