Thunderbird V8-281 4.6L SOHC (1994)
4.
Install the foam seal (F5SZ-6303037-A) around the windshield. Start at the RH or LH A-pillar and pull the A-pillar moulding and headliner
slightly away from the windshield. Carefully push/tuck the seal between them and the glass, working toward the bottom of the opposite side
A-pillar until the seal is positioned out of view. Refer to Figure 2.
5.
Tighten the A-pillar trim screws.
6.
To install the foam seal on the rear glass of the Thunderbird, follow the same procedure as used for the windshield.
7.
Tighten the quarter trim panel attaching screws.
8.
Reinstall the rear seat (Thunderbird only).
