ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Recall - Catalyst Monitor Sensor Connector Defect|Page 3760 > < Recall - Catalyst Monitor Sensor Connector Defect|Page 3758
Page 3
background image

REGIONAL CONTACT

Advise regional office if an owner:

^

cannot be contacted.

^

does not make a service date.

CLAIMS PREPARATION AND SUBMISSION

^

Enter claims using DWE.

^

Refer to ACESII manual for claims preparation and submission information. To claim for "Special Handling", follow the instructions in the dealer
announcement dated 10/26/01.

OWNER REFUNDS

Ford Motor Company will only refund owner-paid repairs made before the date of the owner letter (or after the date of the owner letter if an  emergency
repair was made away from the servicing dealer). Refer to ACESII manual for refund information.

RENTAL CARS

See "Special Handling Guidelines" for claiming a rental vehicle under this program.

Attachment II - Labor and Parts Information

LABOR ALLOWANCES

PARTS REQUIREMENTS / ORDERING INFORMATION

Attachment III - Technical Information

OVERVIEW

The connectors for the catalyst monitor sensors (CMS) may be reversed. The harness will be inspected to determine if the connectors are routed to the
proper CMS. If required, some disassembly of the harness will be necessary to switch the position of the connectors. Self-tests will be performed to
verify the repair and to clear any diagnostic trouble codes (DTCs) related to this repair. The only DTCs related to this program are P1129 (engine
running) and P0136/P0156 (continuous DTCs). If any other DTCs are found, they are not related to this program and should be diagnosed and repaired
under the applicable warranty.

SERVICE PROCEDURE

1.

Raise the vehicle on a hoist.

Recall - Catalyst Monitor Sensor Connector Defect|Page 3760 > < Recall - Catalyst Monitor Sensor Connector Defect|Page 3758