Thunderbird V8-302 5.0L (1984)
Fuel Gauge Sender: Service and Repair
REMOVAL
1.
Remove fuel from fuel tank and lower the tank.
2.
Remove any dirt that has accumulated around the sending unit so that it will not enter the tank or connections.
3.
Disconnect the wiring connector from fuel sender unit.
4.
Loosen the hose clamps and disconnect the tank lines at the sending unit.
5.
Turn the sending unit locking ring counterclockwise and remove the locking ring, sending unit and mounting gasket.
INSTALLATION
1.
Clean the fuel gauge sending unit mounting surface at the fuel tank.
2.
Position a new mounting gasket and the sending unit on the fuel tank and secure it by rotating the locking ring against the stop.
3.
Connect the fuel lines and wiring connector.
4.
Fill the tank and check for leaks.
