ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Air Injection Check Valve > < Air Diverter Valve|Description and Operation|Page 2656
Page 1
background image

Air Injection Bypass Valve: Technical Service Bulletins
Thermactor Air Bypass Valve - Service Tip

Article No. 
94-14-2

07/13/94

^

EMISSION CONTROL - THERMACTOR AIR BYPASS VALVE REPLACEMENT - SERVICE TIP

^

THERMACTOR AIR BYPASS VALVE - SERVICE TIP

FORD:
1991-93 THUNDERBIRD

LINCOLN-MERCURY: 
1991-93 COUGAR

ISSUE:
On subject vehicles with 75,000 miles (120,000 KMS) or more, the polyester silencer pad in the thermactor air bypass valve may become plugged,
resulting in bypass valve failure which could eventually fail the thermactor air pump.

ACTION:
During routine service of the subject vehicles, it is highly recommended that the thermactor air bypass valve be checked by performing the following
procedure.

1.

Start the vehicle and allow the vehicle to warm up for three (3) minutes.

2.

Place hand over (but do not block off) the dump pads on the side of the air bypass valve body.

3.

Air should be felt. If air flow is not detected, replace the air bypass valve.

OTHER APPLICABLE ARTICLES: NONE
WARRANTY STATUS: INFORMATION ONLY
OASIS CODES: 623000

Air Injection Check Valve > < Air Diverter Valve|Description and Operation|Page 2656