Thunderbird V8-302 5.0L HO (1992)
Neutral Safety Switch: Service and Repair
Fig. 4 Neutral Safety Switch Replacement
A4LD
1.
Remove downshift linkage rod from transmission downshift lever.
2.
Apply penetrating oil to downshift lever shaft and nut; then remove downshift outer lever.
3.
Remove switch attaching bolts.
4.
Disconnect multiple wire connector and remove switch from transmission.
5.
Install new switch.
6.
With transmission manual lever in neutral, rotate switch and install gauge pin (#43 drill) into gauge pin holes, Fig. 4. Shank end of drill must be
inserted approximately 15/32 inch into each of the gauge pin holes.
7.
Tighten switch attaching bolts and remove gauge pin.
8.
Reverse remainder of procedure to install.
AOD
1.
Disconnect battery ground cable.
2.
Place transmission gear selector in manual Low position.
3.
Raise and support vehicle.
4.
Disconnect electrical connector from neutral start switch. Lift connector straight up off switch using a long screwdriver under rubber plug of
connector.
5.
Remove switch and O-ring using socket No. T74P-77247-A or equivalent. Use of any tools other than those specified may result in damage to
vehicle.
6.
Reverse procedure to install. Torque switch to 7-10 ft. lbs.
