Thunderbird V8-4.6L VIN W (1997)
18. Install oil pump and oil pump screen cover and tube.
NOTE: Install new O-ring on oil pump screen cover and tube and start all bolts on oil pump and oil pump screen cover and tube before
tightening.
19. Rotate crankshaft to position as shown.
CAUTION: Failure to position crankshaft as shown will cause damage to pistons and/or valve train components.
NOTE: With crankshaft in this position, no piston will be at top dead center (TDC).
20. Rotate crankshaft clockwise 45 degrees. This will position crankshaft at top dead center (TDC) No. 1.
CAUTION: Crankshaft must only be rotated in the clockwise direction and only as far as top dead center (TDC) No. 1.
21. Install camshafts.
22. Install timing chains.
23. Replace crankshaft front seal (6700) in engine front cover if required.