Thunderbird V8-4.6L VIN W (1997)
Timing Cover: Service and Repair
Installation
1. Remove all traces of dirt, oil or previously applied sealant from the engine front cover, cylinder heads and cylinder block sealing surfaces. Sealing
surfaces must be clean and dry before applying sealant.
2. Replace crankshaft front seal (6700) and engine front cover gasket (three each).
3. Apply an 8-12 mm (0.32-0.47 inch) bead of Silicone Gasket Sealant F6AZ-19562-AA or equivalent meeting Ford specification WSE-M4G323-A6
in locations shown.
NOTE:
^
Prior to applying sealer, clean sealing surfaces with Metal Surface Cleaner F4AZ-19A536-RA or equivalent meeting Ford specification
WSE-M5B392-A to remove all residue that may interfere with the sealer's ability to adhere.
^
Install engine front cover and retainers in no more than four minutes after applying sealer.
4. Install engine front cover on engine no more than four minutes after applying sealant.
